Truck Tyre Blowout on the Motorway: What Drivers and Dispatchers Should Do
What to do after a truck tyre blowout: keep control, secure the hard shoulder, who to call in each country, the dispatcher's checklist and how to prevent it.
Picture a loaded artic on a German Autobahn at 85 km/h. There is a bang like a gunshot, the cab drops to one side and the steering wheel tries to tear itself out of the driver’s hands. What happens in the next ten seconds decides whether this becomes a tyre bill or an accident report.
Then the second phase starts: a truck on a hard shoulder, a driver who has to stay alive next to traffic, and a dispatcher trying to get a fitter there before the delivery slot is gone. This guide covers both.
Short answer: Hold the steering wheel firmly with both hands, stay off the brake and let the truck slow down before braking gently. Pull onto the hard shoulder, switch on the hazards, put on a high-visibility vest, set the warning triangle well back and wait behind the crash barrier. Don't change the wheel on the hard shoulder yourself: call 112 or the motorway operator for anything dangerous, then a roadside tyre service.
The first ten seconds: keeping control
Every driving manual says the same thing, because braking is the instinct that causes the crash. The UK driving test explanation is typical: with a front-tyre blowout, keep a firm hold of the steering wheel and slow gradually to a stop; don’t brake hard or steer sharply.
On a truck, where the tyre is matters:
- Steer tyre: the most dangerous case. The truck pulls hard towards the burst side and the steering goes heavy. Grip the wheel with both hands, hold the lane, take your foot off the accelerator and do not touch the service brake until the truck has slowed. Braking shifts weight onto the failed tyre and can pull the truck across lanes.
- Drive tyre: often felt through the seat as a thump and a wobble rather than through the steering. The same rule applies: off the throttle, hold the line, brake gently once speed has dropped.
- Trailer tyre, especially an inner dual: the driver may not notice at all. The neighbouring tyre carries the load until it overheats too. Other drivers flashing their lights, a smell of burning rubber or a TPMS warning are often the only signs.
Once the truck is under control and slowing, use the engine brake or retarder rather than the pedal, signal, and steer gently onto the hard shoulder. If there is no hard shoulder, keep going slowly to the next lay-by or exit if the wheel and rim allow it. Stopping in a live lane is the last resort.
Securing the truck on the hard shoulder
The danger doesn’t end when the truck stops. Do this, in this order:
- Stop as far right as you can (left in the UK and Ireland), wheels turned away from traffic, parking brake on.
- Hazard lights on, and the beacon if you have one.
- Put on the high-visibility vest before you get out, and leave by the passenger door if you can.
- Set the warning triangle well back. On German motorways the ADAC recommends putting it at least 150 metres behind the vehicle, about four marker posts. On a bend, place it before the bend begins.
- Wait behind the crash barrier, not in the cab and not in front of the truck.
Don’t change the wheel on the hard shoulder. A truck wheel with its tyre weighs around 100 kg, the job takes time with your back to the traffic, and the hard shoulder is where trucks drift when drivers get tired. Leave it to a roadside service with a protected vehicle.
If the work needs part of a lane, the fitter cannot simply close it. German police are clear that closing a lane, or even part of the carriageway, on your own initiative is prohibited; the police or the motorway maintenance service arrange it.
Who to call, and in which country it is different
112 works everywhere in the EU. Call it first if anyone is hurt, if the truck is in a live lane, or if debris from the tyre is on the carriageway. Debris from a burst truck tyre is a real danger to the cars behind.
For the repair itself, most countries let you call any roadside tyre service you want. Two exceptions catch foreign fleets:
- France: on autoroutes and expressways, only approved breakdown companies may intervene. You call through the orange emergency phones (roughly every 2 km) or 112, and the operator sends the approved company, which must reach you within 30 minutes. Prices for cars are regulated, but for vehicles of 3.5 t and over the breakdown and towing rates are free, so ask for the price before work starts.
- Belgium (Wallonia): breakdowns on motorways are coordinated through the police (101), and unapproved tow companies may not intervene.
Elsewhere, your own service or your tyre contract partner can come to you. If the truck is on a motorway in Germany, Austria or Czechia, tell the dispatcher at the tyre service exactly that, because not every mobile fitter works on motorways.
The dispatcher’s checklist
The dispatcher turns a scary phone call into a job a fitter can complete in one visit. Get these details from the driver before you call anyone:
- Exact location: road number, direction of travel, kilometre post or the nearest junction, and the GPS position from the telematics.
- Which tyre: axle and side (for example “drive axle, left, inner”). Ask the driver to check the neighbouring dual too.
- Tyre size and load index, read off the sidewall of the tyre next to it, such as 315/70 R22.5 154/150L. This is the information the fitter needs most to bring the right tyre.
- Is the rim damaged, and are the brake lines, mudguard or wiring torn? A ripped air line changes the job.
- Load: ADR goods, temperature-controlled cargo or an urgent slot change the priorities.
- Driver’s remaining driving time. A two-hour wait can end the day’s driving.
- Photos of the tyre, the sidewall markings and the scene, for the warranty claim, the insurer and your own records.
Then call your tyre partner or roadside service, tell the customer about the delay with a realistic new arrival time, and record the time of each step. If the delay leads to a claim later, those times are your evidence.
Never reinflate a tyre that was driven flat
This rule protects the driver, the fitter and anyone standing nearby. When a truck tyre runs underinflated, the steel cords in the sidewall flex and weaken. Re-inflated later, the sidewall can split open along its whole circumference. Tyre engineers call this a “zipper” failure, and it releases the air with explosive force.
The industry rule is simple: if a tyre is more than 20% below its recommended pressure, it must be removed and checked by a qualified technician, and a completely flat tyre must never be reinflated. Zipper failures most often hit the inner tyre of a twin set, on the drive or trailer axle. If one dual has failed, the other one has been carrying double the load and must be inspected too.
What a roadside tyre call-out costs
There is no single price, but the bill is built from the same parts everywhere:
- Call-out and travel: often a fixed fee plus kilometres from the workshop.
- Time of day: nights, weekends and public holidays usually carry a surcharge.
- The tyre itself: at roadside prices, which are rarely your contract price unless the service is your contract partner.
- Extras: valve, rim, wheel nuts, disposal of the old tyre, and any second tyre that turns out to be damaged.
- Motorway conditions: approved-operator schemes, such as France’s, and lane-closure safety arrangements can add cost.
Three things keep the bill down. First, agree prices in advance with a tyre network that covers your corridors, so the driver calls a number, not a search engine. Second, standardise tyre sizes across the fleet, so the fitter is more likely to have the right one in the van. Third, decide your spare-wheel policy deliberately: a spare saves hours on a remote road, while a spare-less fleet saves weight but depends entirely on the service.
How to prevent blowouts
Most blowouts are not bad luck. The usual causes are well known:
- Underinflation, the cause tyre makers warn about most. A tyre that runs soft flexes more, overheats and fails.
- Overloading, which does the same thing faster.
- Heat from dragging brakes or a seized hub, especially on trailer axles.
- Damage from kerbs, potholes or debris, and old tyres with cracked sidewalls.
Tyre pressure monitoring helps catch the first cause early. In the EU, TPMS became compulsory on all newly registered trucks, trailers and semi-trailers over 3.5 t in July 2024, after applying to new vehicle types since July 2022. Older vehicles can be retrofitted. A warning on the dashboard is worth far more than a gauge check once a week, because many failures start as a slow leak on the road.
Add one habit to every walk-round check: look at and touch the inner duals. They are the tyres nobody sees, and the ones that fail without the driver noticing.
Next step
If your trucks run through the Alps or Scandinavia this winter, check the winter tyre and snow chain rules for trucks by country before the season, because the wrong drive tyres can stop a truck at a checkpoint just as surely as a blowout.
Sources and last check: UK DVSA theory-test guidance on front-tyre blowouts; ADAC on securing a breakdown on the Autobahn; Polizei NRW (Bochum) guidance on securing trucks on motorway hard shoulders; French Ministry of Economy (DGCCRF) on autoroute breakdowns; RTBF on Wallonia’s motorway breakdown scheme; Continental Tyres UK on inflation and zipper failures; trans.info on the EU TPMS requirement under Regulation (EU) 2019/2144. All checked on 19 November 2026.
Frequently asked questions
Should I brake when a truck tyre blows out?
No, not at first. Hold the steering wheel firmly with both hands, take your foot off the accelerator and keep the truck in its lane. Hard braking shifts weight onto the failed tyre and can pull the truck across lanes. Brake gently only once speed has dropped, using the engine brake or retarder where you can.
Can I change a truck wheel on the hard shoulder myself?
You shouldn't. A truck wheel with its tyre weighs around 100 kg, the job takes time and you work with your back to fast traffic. Secure the truck, wait behind the barrier and call a roadside tyre service. In Germany, closing a lane for the work is only allowed through the police or motorway maintenance service.
Who do I call after a breakdown on a French autoroute?
Use the orange emergency phones, roughly every 2 km, or call 112. On autoroutes and expressways only approved breakdown companies may intervene, and the approved company must reach you within 30 minutes. For vehicles of 3.5 t and over, prices are not regulated, so ask for the price before work starts.
Can I drive on a truck with one blown dual tyre?
Only slowly, to the nearest safe place to stop. The remaining tyre now carries the load of two, overheats and can fail in turn, and the damaged tyre can throw rubber at following traffic. Once stopped, have both tyres of the pair inspected. The survivor may have internal damage you cannot see.
Is it safe to reinflate a truck tyre that went flat?
No. A truck tyre that has run more than 20% below its recommended pressure can have damaged sidewall cords and may split open explosively when reinflated. It must be removed from the rim and inspected by a qualified technician first. A completely flat tyre should never be reinflated on the vehicle.